I did something foolish! I own a metal fabrication shop. One of the things we make is pipe flanges. I have a ring and circle shear that cuts them out, and we use an ironworker to punch bolt slots in them. The punch and die sometimes will leave a razor sharp burr on the edge of the slots. We grind them smooth. ....except the ones that we miss. I wasn't looking, and grabbed one that had been had missed......and, of course, I didn't have gloves on. I had gotten up from my desk to go into the shop to measure something. I didn't take the 5 seconds it would have taken to slip my gloves on.
2017 Jason Wolverton spruce/maple, 640, "Luz Blanca"
2016 Kenny Hill New World Estudio 640, cedar
2015 Kenny Hill Performance 640, C/IR
2017 Kenny Hill Player Cutaway, 640, Sp